◆ instructions

instr_NO_operation has the value of zero and the follwoing instructions are increased by one at each step.

The last enum line, instr_Trimmer_setting, is not an instruction but the information of the total number of instructions.

Enumerator
instr_NO_operation	NOP, the fw version is replayed.
instr_Shut_Down_ON_OFF	µ-controller can be maintained always ON
instr_inizializza_tutto_da_zero	µ-controller is reset. The perifelal are all initialized.
instr_detector_Vbias_we_want_to_set	The voltage we intend to set to the detector. This command does not apply the voltage.
instr_Vbias_to_be_set	The voltage set with instr_detector_Vbias_we_want_to_set is set to the detector.
instr_Relays_driver_set_reset_channel	Set / reset of the relais that manage the detectors.
instr_detector_scrittura_lettura_trimmer_bias	Write /read to /from the trimmers for the detectors biases.
instr_preamplifier_gain_low_high_set	Set /reset of the large gain for the preamplifier.
instr_preamplifier_temperature_meas	Measure the preamplifier temperature.
instr_preamplifier_memory	Write /read the preamplifier EPROM.
instr_ouput_offset_we_want_to_set	Set the output offset to set channel per channel.
instr_output_offset_to_be_set	Adjust the ouput voltage that was previously set at instr_ouput_offset_we_want_to_set.
instr_preamplifier_scrittura_lettura_trimmer_offset	Write /read to /from the trimmers for the preamplifier offset adjustment.
instr_PGA_gain_set	Set the PGA gain value.
instr_PGA_set_reset_pre_PGA_gain	Set /reset of the first stage of PGA.
instr_PGA_DAC_GAIN_CROSS	Set the gain of the second stage of the PGA.
instr_ERROR_inspection	quering about the presence of any error
instr_ERROR_echo_on_off	if enabled, echo of the error via CAN as soon as the error is verified
instr_ADC_LETTURA	ADC reading, the following byte from the CAN set the reading node.
instr_readback_variables	Variables Readback
instr_readback_node_voltages	Nodes voltage read from external ADC.
instr_offset_trimmer_calibration	fine and coarse trimmer calibration for ofset compensation
instr_DetBias_trimmer_calibration	fine and coarse trimmer calibration for detector bias compensation
instr_EPROM_read_write	read from preamplifier or mainboard or post frontend board EPROM
instr_connect_disconnect_mux_node	select/deselect a node from the analog mux
instr_LED_ON_OFF	LEDs can be switched ON/OFF for test and diagnostic.
instr_periferal_reset	I2C, SPI and CAN can be reset.
The_total_number_of_instrucions	This is the total numebr of instructions, not an instruction.

Definition at line 15 of file CROSS_command_parser.h.