Configure_Bit_Address_for_CAN()

void Configure_Bit_Address_for_CAN

(

void

)

Switches for the selection of the hw CAN bus address. Pin are set as input with internal pull-up.

Returns

No input parameters

void Configure_Bit_Address_for_CAN(void)
{
    uint8_t iii;
// B0, ... B7 addresses
    for (iii=0; iii<8;iii++){
        status= PIN_Configure(CAN_indirizzo_hw[iii].porta_num, CAN_indirizzo_hw[iii].pin_num, PIN_FUNC_0,PIN_PINMODE_PULLUP, PIN_PINMODE_NORMAL);       
        GPIO_SetDir(CAN_indirizzo_hw[iii].porta_num, CAN_indirizzo_hw[iii].pin_num, GPIO_DIR_INPUT);    
    }
 
}

Definition at line 415 of file Gpio.c.