ADC_Sleep_fun()

void ADC_Sleep_fun

(

uint8_t

up_down

)

ADC is sent to sleep mode.

Returns

No Parameters, the actual result is sent to the CAN bus output throught tx_data.

void ADC_Sleep_fun(uint8_t up_down){
    const porta_pin_def  *ref_locale;
    if( up_down) up_down=1;
    if ( up_down == I2C_mux_Scheda_giu){
        ref_locale =&ADC_Chip_Sel_down;             // Viene abbassato il chip selector ADC per la lettura
    }else{
        ref_locale =&ADC_Chip_Sel_up;
    }
    
    if( up_down <2){
            GPIO_PinWrite(ref_locale->porta_num, ref_locale->pin_num, 0);
            
            uint8_t valore_da_trasmettere[]={ ADC_mode_reg, ADC_power_down_com};
            
            SPIdrv->Send ( &valore_da_trasmettere ,2); 
            uint8_t troppa_attesa=0;
            while( (SPIdrv->GetStatus().busy) && (troppa_attesa <250) ){
                Aspetta_tanti_ms(1);
                troppa_attesa++;
            } //wait end of transmission     ;
            if((troppa_attesa>=250) || (Error_bad_operation)) ERROR_codifica_errore(up_down, error_address_SPI, SPI_error_EVENT_DATA_LOST,1);
            GPIO_PinWrite(ref_locale->porta_num, ref_locale->pin_num, 1);
}
}

Definition at line 262 of file Adc.c.