detector_chip_select_bias

const struct chip_select_type detector_chip_select_bias[6]

extern

This is the vector of constant values which allows to enable the relays drivers of each channels, one at a time. Every selecting pin to be enabled needs to select the chip, namely the port to which is connected, and the pin on the port.

Note

... & I2C_to_Parallel_2_ini_set The analog mux ADG1408 chip select is idle when 0 it equals 0x7F
... & I2C_to_Parallel_2_ini_set is also set for the reson above.
More about the ADG1408 can be found at Multiplexer_strutture_funzioni_definizioni.
😉

Definition at line 138 of file I2C_to_parallel.c.